Disc Wood Chip Machine factory

Malfunctions are taboo in industrial production equipment. In fact, many people do not want malfunctions to occur on wooden chips. Once a malfunction occurs, it will also delay the normal production of the equipment, and the losses in industrial production will be even greater. Therefore, the disc wood chip machine factory will share with you methods to reduce the failure rate of the disc wood chip machine.
1. After 300 hours of operation, clean the bearings and replace the oil.

2. Operators should not wear gloves. If there is a blockage, do not insert your hand into the working chamber of the wood cutter.

3. During the operation of the disc disc wood chip machine, attention should be paid to its operation at all times, and the feeding should be uniform, without overloading for a long time.
4. After turning on, let the device idle for 2-3 minutes and listen carefully for the sound of operation to see if it is normal. The machine can only work after it rotates smoothly.
5. After the equipment is working, let it idle for 2-3 minutes to completely discharge the materials in the machine. After shutdown, clean and maintain the machine. Do not stop the machine immediately.
6. During equipment operation, operators are not allowed to leave the unit. During operation, the machine must not be disassembled or the working conditions inside the machine must not be observed. Maintenance tools must not be placed on the machine or packaging.
7. Before starting, check whether the connecting bolts of each part of the unit are tightened, whether the power cord is intact, whether the tension of the transmission belt is appropriate, and whether the motor shaft is parallel to other machine shafts.
8. The fixed operation of the equipment should be fixed on a cement foundation. If the workplace is frequently replaced, equipment and motors should be installed on a base made of angle iron. If the equipment is powered by a diesel engine, the power of both should be matched, the pulley grooves of both should be consistent, and the outer end face of the pulley should be in the same plane.
Through the introduction of reducing the failure rate of the disc disc wood chip machine, it is understood that timely cleaning is necessary to prevent equipment blockage, which is beneficial for the operation of the equipment. Improve its performance and quality, and reduce the occurrence of malfunctions. I hope this answer is helpful to you.