Wood chipper installation

The process of installing a wood chipper can be divided into the following steps:

1. Power off and safety preparation

When installing and adjusting the wood chipper, first make sure that the power supply has been cut off to prevent accidents213. All fixtures should be fixed during debugging to prevent tools from falling off or loosening213. In addition, it is necessary to check whether there are debris and branches around the wood chipper that affect the operation and operation, and first determine the rotation direction of the feed roller after power on, so that the equipment can idle for about 5 minutes, and pay attention to listen and observe whether the equipment is abnormal.

2. Equipment positioning and installation direction determination

The wood chipper should be placed stably, and the installation direction should be determined according to the actual situation of the site and raw materials12. Generally, small models do not require foundation laying, and users can directly power on the test machine for use. For medium-sized and above equipment, the main machine foundation and the inlet and outlet conveying system foundation are made according to the basic drawings provided by the manufacturer, and then the manufacturer sends professional technicians to guide the installation.

3. Install blades and other components

Two, three or four flying knives are installed on the knife roller, and the flying knives are fixed to the knife roller through the pressure block with the manufactured flying knife bolts. Wood chippers are popular among users for their cutting, large output, no clogging, and good quality of finished products.

4. System debugging and idling

After adjustment, clean the inside of the wood chipper to avoid damage due to lack of tools. After adjusting the blade, let the machine run idly. After confirming that there is no fault, a small amount of material can be sent. After normal, continue normal production.

5. Safety precautions

Because the blade is sharp, please try to wear gloves when adjusting the knife to avoid scratching your hands. After installation, conduct a test machine experiment to see if the installation of the wood chipper is proper and successful.

The above is the installation method of the wood chipper, I hope it will be helpful to you.